Header menu link for other important links
X
Integrating model based fault diagnosis with model predictive control
Published in
2005
Volume: 44
   
Issue: 12
Pages: 4344 - 4360
Abstract
Model predictive control (MPC) schemes are typically developed under the assumption that the sensors and actuators are free from faults. Attempts to develop fault-tolerant MPC schemes have mainly focused on dealing with hard faults, such as sensor or actuator failures, process leaks, etc. However, soft faults such as biases or drifts in sensors or actuators are more frequently encountered in the process industry. Occurrences of such faults can lead to degradation in the closed loop performance of the MPC controller. Since MPC controllers are typically used to control key operations in a chemical plant, this can have an impact on safety and productivity of the entire plant. The conventional approach to dealing with such soft faults in MPC formulations is through the introduction of additional artificial states to the model. The main limitation of this approach is that number of artificial extra states introduced cannot exceed the number of measurements. This implies that it is necessary to have a priori knowledge of which subset of faults are most likely to occur. In this paper, an active on-line fault-tolerant model predictive control (FTMPC) scheme is proposed by integrating state space formulation of MPC with the fault detection and identification (FDI) method based on generalized likelihood ratios. The fact that both these schemes use a Kalman filter as their basis facilitates tight integration of these two components. The main difference between the conventional MPC formulation and FTMPC formulation is that the bias corrections to the model are made as and when necessary and at qualified locations identified by the FDI component. The FTMPC eliminates offset between the true values and set points of controlled variables in the presence of a variety of faults while conventional MPC does not. Also, the true values of state variables, manipulated inputs, and measured variables are maintained within their imposed bounds in FTMPC, while in conventional MPC, these may be violated when soft faults occur. These advantages of the proposed scheme are demonstrated using simulation studies on a CSTR process and experimental studies conducted on the temperature control of a coupled two tank heater system. © 2005 American Chemical Society.
About the journal
JournalIndustrial and Engineering Chemistry Research
ISSN08885885
Open AccessNo
Concepts (13)
  •  related image
    Actuators
  •  related image
    Closed loop control systems
  •  related image
    Computer simulation
  •  related image
    Kalman filtering
  •  related image
    Maximum likelihood estimation
  •  related image
    Sensors
  •  related image
    Signal filtering and prediction
  •  related image
    Fault detection and indentification (fdi)
  •  related image
    Model predictive control (mpc)
  •  related image
    Process leaks
  •  related image
    State variables
  •  related image
    Fault tree analysis
  •  related image
    Fault diagnosis